Galmet heat pumps
Air/water monoblocGround sourceHot water 5 series
Galmet (Galmet Sp. z o.o. Sp. K.) is a Polish manufacturer of heating and hot water equipment based in Głubczyce, which describes itself as active for more than 40 years. Its heat pump range includes the Airmax3 R290 and Airmax2 air-to-water heat pumps, the Prima R32 monoblock, the Maxima brine-to-water heat pumps and the Basic hot water heat pump.
Checked November 2, 2026 · Głubczyce, Poland · Manufacturer website · Datasheet library
Photo: Galmet
Grant lists
BAFA WEP (Germany)
1 / 5 checked November 4, 2026
ZUM (Poland)
5 / 5 checked November 4, 2026
Galmet in Zerofy
Zerofy has no integration for Galmet yet. Where a series below has an SG Ready input, Zerofy can still switch it through a Shelly relay. The heat pump comparison lists every brand Zerofy supports.
Galmet heat pump types
Galmet Air-to-water monoblock
The whole refrigerant circuit sits in one outdoor unit; only water pipes run into the house. The most common choice for retrofits, because no refrigerant lines need to be installed inside.
Air/water monoblocR290
Galmet Airmax³
3 models
- Output
- 3.9–6.1 kW
- SCOP 35 °C
- 4.47–4.73
- Max. flow
- 68 °C
- BAFA WEP
- 3 models listed
- ZUM
- 3 models listed
- Zerofy
- Via SG Ready
Air/water monobloc
Galmet Airmax²
8 models
- Output
- 6.2–29.8 kW
- SCOP 35 °C
- –
- Max. flow
- 57 °C
- BAFA WEP
- No model on the list
- ZUM
- 7 models listed
- Zerofy
- Not supported
Air/water monoblocR32
Galmet Prima
7 models
- Output
- 8.4–15.9 kW
- SCOP 35 °C
- –
- Max. flow
- 65 °C
- BAFA WEP
- No model on the list
- ZUM
- 7 models listed
- Zerofy
- Via SG Ready
Galmet Ground-source (brine/water)
Draws heat from a borehole or ground loop, so the source stays at a steady temperature all winter. Higher efficiency and no outdoor noise, but boreholes cost money and need a permit.
Ground source
Galmet Maxima
7 models
- Output
- 7.3–16.6 kW
- SCOP 35 °C
- –
- Max. flow
- 60 °C
- BAFA WEP
- No model on the list
- ZUM
- 11 models listed
- Zerofy
- Not supported
Galmet Hot water heat pumps
A small heat pump built onto a hot water tank. It heats drinking water only and is a good way to turn surplus solar into stored heat – or to add hot water to a house that is otherwise heated differently.
Hot water
Galmet Basic
2 models
- Output
- –
- SCOP 35 °C
- –
- Max. flow
- 55 °C
- BAFA WEP
- No model on the list
- ZUM
- 2 models listed
- Zerofy
- Not supported
Galmet series at a glance
| Series | Type | Output | SCOP 35 °C | SCOP 55 °C | Refrigerant | Max. flow | BAFA WEP | ZUM | SG Ready | Modbus | EEBUS |
|---|---|---|---|---|---|---|---|---|---|---|---|
| Airmax³ | Air/water monobloc | 3.9–6.1 kW | 4.47–4.73 | 3.31–3.71 | R290 | 68 °C | 3 models listed | 3 models listed | Yes | Yes | –Not documented |
| Airmax² | Air/water monobloc | 6.2–29.8 kW | – | – | – | 57 °C | No model on the list | 7 models listed | –Not documented | –Not documented | –Not documented |
| Prima | Air/water monobloc | 8.4–15.9 kW | – | – | R32 | 65 °C | No model on the list | 7 models listed | Yes | –Not documented | –Not documented |
| Maxima | Ground source | 7.3–16.6 kW | – | – | – | 60 °C | No model on the list | 11 models listed | –Not documented | –Not documented | –Not documented |
| Basic | Hot water | – | – | – | – | 55 °C | No model on the list | 2 models listed | –Not documented | –Not documented | –Not documented |
Heating output is the figure in the manufacturer's datasheet; the basis (nominal output at A7/W35 or B0/W35, or design heat load) differs between brands, so check the datasheet before comparing. * = design heat load Pdesignh at 35 °C from the BAFA portal.
Sources
Specifications come from the manufacturer's datasheets linked above, grant status from the official lists below, checked November 2, 2026:
- galmet.com.pl/produkty/pompy-ciepla
- galmet.com.pl/produkty/pompy-ciepla/powietrzne-do-co-cwu/airmax3-r290-2-15
- galmet.com.pl/produkty/pompy-ciepla/powietrzne-do-co-cwu/airmax2-6-15
- galmet.com.pl/produkty/pompy-ciepla/powietrzne-do-co-cwu/prima-r32-6-16
- galmet.com.pl/produkty/pompy-ciepla/powietrzne-do-co-cwu/prima-split-r32-6-16
- galmet.com.pl/produkty/pompy-ciepla/gruntowe-do-co-cwu/maxima-7-16
- galmet.com.pl/produkty/pompy-ciepla/powietrzne-do-cwu/basic
- galmet.com.pl/uploads/Katalog_produktow_Galmet_PL_21_08_2026_417cdd8e4f.pdf
- elan1.bafa.bund.de/zvi-ui/wep/waermepumpen
- lista-zum.ios.edu.pl/
- BAFA Wärmeerzeuger-Portal – Wärmepumpen – checked November 4, 2026
- Lista ZUM (Instytut Ochrony Środowiska) – checked November 4, 2026
- EEBUS certified devices – checked November 2, 2026
SG Ready is a label of the Bundesverband Wärmepumpe (BWP) e.V.; “Yes” means the manufacturer documents the two-input interface or declares it on the BAFA portal, not that the series carries the BWP label – the label list is at waermepumpe.de. EEBUS is a standard of the EEBus Initiative e.V.; Modbus is a registered trademark of Schneider Electric, licensed to the Modbus Organization. Product names, logos and photos belong to their manufacturers and are shown to identify the products. Grant data: BAFA Wärmeerzeuger-Portal and Lista ZUM (IOŚ-PIB) as of the dates shown; the SCOP at 55 °C in the BAFA tables is calculated by Zerofy from the portal's ηs value.
Heat with your own solar power
Zerofy moves your heat pump's runtime into the hours with surplus solar power or low prices – automatically.
Get ZerofyOther heat pump brands
Compare all brands in the heat pump database.